America’s Gate Company offers a wide selection of ready-made and custom fabricated gates, no matter the applications. As the gate division of The American Fence Company, America’s Gate Company has over 55 years of experience in gate design, fabrication and installation. With either fabrication facilities and a large team of certified welders and computer-aided designers, your gate will be fabricated to match your unique requests.
A cantilever gate should be installed on a level plane so that the gate can roll in both directions without having additional gravitational pull as a result of the weight of the gate. Slight adjustments can be made to allow for some minor slope, however, too much slope and the gate could prove to be dangerous while rolling down hill. If you don't have your cantilever gate yet, check out America's Gate Company's extensive guide on how to select your cantilever gate that will help you choose every detail of your cantilever gate.
To install a cantilever gate:
- Install the two bottom cantilever rollers so that the rollers are toward the inside of the fence while fabric is on the outside. The rollers should be approximately 1” off the ground. Place a piece of rail across the two rollers. Place a level on the rail and adjust the rollers up or down so that the rail is level. Also, make sure that the rollers are adjusted so that the gate will not slide into the grade as a result of a slope. Tighten the rollers.
- Install the two top cantilever rollers so the rollers will capture the gate once in place. Hand tighten the rollers.
- Install the gate onto the two bottom rollers. Stand the gate up. When in the upright position, slide the two rollers over and onto the gate. With the gate touching both bottom rollers (balanced in-between the rollers), tighten the two top rollers, leaving a ½” clearance between the rollers and top of gate frame (track or 2.5” pipe). Tighten the rollers.
- Roll the gate forward and backwards through the opening. If the gate binds, you may have to raise one of the top rollers.
- Adjust the rollers as needed so that you keep the gate as close to the ground as possible, but do not place the rollers below grade or buried. In the winter, the areas around the rollers will fill with snow and freeze.
- Do not dig a trench for the gate to fully open. Again, in the winter the snow will freeze the gate in place.
- Fully tighten all rollers upon completing final adjustments.
- Install the latch assembly. If installing a gate operator, use the large “V” receiver that allows the gate to be channeled into the receiver. If manually operating the gate, use a cantilever locking device so that a padlock may be applied.
© 2018 The American Fence Company. All rights reserved. Permission granted to reproduce for personal and educational use only. Commercial use, copying or distribution is prohibited without express written permission from The American Fence Company.
© 2022 The American Fence Company. All rights reserved. Permission granted to reproduce for personal and educational use only. Commercial use, copying or distribution is prohibited without express written permission from The American Fence Company.