A rolling gate is great for applications with not enough room to store cantilever gate and openings with a fair amount of slope. However, you must have a smooth surface to roll the gates from ground wheels along the opening. To install a rolling gate:
- Make sure that you set your posts that will support your track on 8’ centers and used at least 2 ½” Sch 40 posts.
- A rolling gate uses two wheels installed on the back vertical support of the gate. These wheels run along track that is installed along the inside of the fence.
- Install your universal track brackets one foot from the bottom of the fence and one foot down from the top of the fence. The brackets are installed so that the U-bolt is below the track sleeve. You will need to install enough brackets to support as many 8’ lengths of track as required to bring your gate to the full opening, i.e. 20 opening will require three lengths of track (24’).
- Measure from bracket to bracket. Using 1 5/8” Sch 40 pipe, cut your track and install between the brackets. Be sure that your track is tight between the brackets so that we do not create a seam for the wheels to get caught-up. Once complete you should have a top and bottom track that is consistently the same distance apart from one end to the other. This is important to prevent the track from binding on the rear track wheels.
- Install your rear track wheels on the rear vertical support of the gate from. The wheels will be approximately one foot from the top and bottom of the gate. The wheels will be installed on the outside face of the gate so as to ride on top of the track. Hand tighten.
- Install the double wheel carrier as far forward as you can on the bottom horizontal member of the gate.
- Placing the gate in the opening with both rear track wheels on top of the track, adjust the rear track wheels so that both wheels bear down on the track. Make sure the lower guide on the wheels captures the track so that you can not lift the gate off the track but the guide does not bind while traveling the track. Tighten the wheels.
- Roll the gate through the opening. Adjust the rear track wheels as necessary. The double wheel assembly has an axle trim bolt that allows you to control the direction of the gate as it rolls through the opening. Adjust as necessary.
- Using two end bands that fit around the latch post, install the offset lock n’ latch so that when the gate comes fully closed the tab on the latch is engaged, capturing the gate frame and allowing you to padlock the latch.
- You may have to adjust the double wheel assembly back on the frame so that the gate will engage the latch.
- Firmly secure all nut & bolt connections to avoid future movement.
© 2018 The American Fence Company. All rights reserved. Permission granted to reproduce for personal and educational use only. Commercial use, copying or distribution is prohibited without express written permission from The American Fence Company.
© 2024 The American Fence Company. All rights reserved. Permission granted to reproduce for personal and educational use only. Commercial use, copying or distribution is prohibited without express written permission from The American Fence Company.